Xpresskit CANMAX400 Installation Manual - Please Note:
Other manuals for CANMAX400:
Installation Manual
of
7
1
3
2
2
Please Note:
When a CANMAX400 is used in D2D with either Viper
, Clifford
or Python
, the jumpers
on the remote starter
be placed in the
operating position.
™
™
™
MUST
Horizontal
Jumper
position
Rev.: 20101015
Platform: CANMAX400
Firmware: GM10
© 2010 Directed Electronics. All rights reserved.
Vehicle Canbus Integration System
Module Programming
Page 4
Solid Red
x3 Secs
If connected in D2D:
Connect the 4-pin D2D harness.
If connected in W2W:
Connect the 12-pin harness.
Connect the 20-pin harness to the module.
Caution! The 20-pin connector can be easily plugged in backwards.
When all the connections are correctly done, the LED will turn ON solid GREEN for 3 seconds.
20-pin
12-pin
The programming sequence procedure was completed successfully.
4-pin