Xpresskit DBALL Installation Manual - page 15
Page 15
LED Diagnostics & Troubleshooting
Rev.: 20160608
Platform: DBALL/DBALL2
Firmware:
CHRYSLER3 Remote Start Ready (RSR) Installation
© 2016 Directed. All rights reserved.
LED
Description
Troubleshooting
Module has no power.
Check the power connections.
Start of programming is normal
If the LED is red after the ignition is ON, check for CAN-High
and CAN-Low connections as the ignition is not seen on
CAN.
CAN programmed and waiting for
bypass programming.
Normal operation
Waiting for offline key2go
programming.
Normal operation
Module successfully programmed or
is already programmed.
Normal operation
Module programming - Error codes
CAN not detected.
Check the Tan - Tan/Black wire connections. Wake up the
data bus by turning the ignition on and try again.
Bypass data not detected.
Check the bypass line connection, make sure there is a
continuity between the 2 sides of the cut and turn the ignition
ON. Make sure the battery was removed when turning the
ignition ON.
External Module Synchronisation
Diagnostic OBDII feature not
initialized.
Diagnostic OBDII BUS statuses like DTC codes will not be
available on SmartStart because the BUS was not detected.
Please check your HSCAN connections, reset, and
reprogram the module. SmartStart can still be used but will
work with limited statuses.
Run safe shutdown.
Brake shutdown.
No key detected shutdown.
Speed detected.
Remote Start sequence (status)
GROUND OUT ON (GWR) command
received.
Otherwise, the Ground While Running (status) signal was lost
or was never received by the module. Commands can come
from RF, D2D or W2W.
IGNITION ON command received.
Otherwise, the ignition signal was not received by the module.
In a W2W install, it will show only if the ignition input wire is
used.
START ON command received.
Otherwise, the start signal was not received by the module. In
a W2W install, it will show only if the ignition input wire is
used.
Module programming
Shutdown codes
Used to check the installation and for troubleshooting
purposes. Used to check for internal safety operation. Does
not represent an error.
Solid and
quick flash
Flashes
red, red,
orange
Solid
Flashes
orange
Flashes
green
Off
Flashes
red x2
Flashes
red x3
Flashes
green
Flashes
green
Flashes red
& orange
Flashes
red x3
Flashes
red x2
Flashes
red x1
Flashes
red x4