1. DL manuals
  2. Xpresskit
  3. Automobile Accessories
  4. DBALL
  5. Installation Manual

Xpresskit DBALL Installation Manual

Summary of DBALL

  • Page 1

    Index installation guide update alert: firmware updates are posted on the web on a regular basis. We recommend that you check for firmware and/or install guide updates prior to installing this product. Ford, lincoln and mercury transponder immobilizer control and factory alarm disarm. Rev.: 20121128...

  • Page 2

    Rev.: 20121128 platform: dball firmware: ford1 © 2012 directed. All rights reserved. Page 2 vehicle application guide (ford) the following table lists the vehicles and features which are compatible with this product. The number assigned to each year allows you to determine which passive anti-theft s...

  • Page 3

    Rev.: 20121128 platform: dball firmware: ford1 © 2012 directed. All rights reserved. Vehicles 2 0 1 3 2 0 1 2 2 0 1 1 2 0 1 0 2 0 0 9 2 0 0 8 2 0 0 7 2 0 0 6 2 0 0 5 2 0 0 4 2 0 0 3 2 0 0 2 2 0 0 1 2 0 0 0 d l -d is a rm f a c to ry s e c u ri ty k e y 2 g o p k -i m m o b ili z e r b y p a s s - d ...

  • Page 4

    Rev.: 20121128 platform: dball firmware: ford1 © 2012 directed. All rights reserved. Page 4 key2go & 1key programming note: key2go feature is only functional with 40-bit encryption, see "understanding the difference between a ford 80 bit & a 40 bit" on page 5 for more information. This feature is re...

  • Page 5

    Rev.: 20121128 platform: dball firmware: ford1 © 2012 directed. All rights reserved. Ford introduced an 80-bit encryption in late 2009 and this caused a lot of confusion as to which models it was available on. The main question is which models use the 80 and which use the old 40 bit? Contrary to pop...

  • Page 6

    Rev.: 20121128 platform: dball firmware: ford1 © 2012 directed. All rights reserved. Page 6 disarm testing (read through all steps before proceeding) 2 5 4 arm the factory alarm on your vehicle. Position the key next to the ignition barrel in a way that you can free your hands, and have a few jumper...

  • Page 7

    Rev.: 20121128 platform: dball firmware: ford1 © 2012 directed. All rights reserved. Installation type 1 - vehicles without factory alarm (-) gwr (status) 9:pink: (+) ignition input 10:blue/white: (-) gwr (status) input 13:red: (+) 12v (+) 12v 14:black: (-) ground (-) ground 10: yellow/black: tx 11:...

  • Page 8

    Installation type 2 - vehicles with factory alarm (-) gwr (status) 9:pink: (+) ignition input 10:blue/white: (-) gwr (status) input 3 red/white: (-) trunk input 2 blue: (-) unlock input 13:red: (+) 12v (+) 12v 14:black: (-) ground 10: yellow/black: tx 11: yellow/red: (+) 12v 11: orange/black: rx 12:...

  • Page 9

    Rev.: 20121128 platform: dball firmware: ford1 © 2012 directed. All rights reserved. Page 9 wiring chart - igntition switch (ford vehicles) type (+) 12v pin (+) ignition pin (+) accessory 1 pin (+) keysense pin ford crown victoria 2005-11 1 lt. Green/violet 9 violet/orange 1 gray/yellow 7 gray/yello...

  • Page 10

    Rev.: 20121128 platform: dball firmware: ford1 © 2012 directed. All rights reserved. Page 10 wiring chart - p.A.T.S. Connector (ford vehicles) type rx pin tx pin ford crown victoria 2005-11 4 gray/orange 4 white/lt. Green 3 crown victoria 2003-04 4 gray/orange 3 white/lt. Green 4 econoline 2009-12 3...

  • Page 11

    Rev.: 20121128 platform: dball firmware: ford1 © 2012 directed. All rights reserved. Page 11 wiring chart - igntition switch (mercury & lincoln vehicles) type (+) 12v pin (+) ignition pin (+) accessory 1 pin (+) keysense pin lincoln aviator 2003-05 4 yellow 4 red/lt. Green 1 gray/yellow 6 lt. Green/...

  • Page 12

    Rev.: 20121128 platform: dball firmware: ford1 © 2012 directed. All rights reserved. Page 12 wiring chart - p.A.T.S. Connector (mercury & lincoln vehicles) type rx pin tx pin lincoln aviator 2003-05 2 gray/orange 4 white/lt. Green 3 ls 2000-06 2 gray/red 4 white/red 3 mark lt 2006-08 2 gray/orange 4...

  • Page 13

    Rev.: 20121128 platform: dball firmware: ford1 © 2012 directed. All rights reserved. Note that 2 keys are required to complete the programming (for key2go see page 17). Refer to the led diagnostics section on page 19 for more information and for troubleshooting purposes. 3 4 insert the first key and...

  • Page 14

    Rev.: 20121128 platform: dball firmware: ford1 © 2012 directed. All rights reserved. 6 8 release the programming button. 7 wait for at least 3 seconds, but 10 seconds, then press and hold the programming button. No more than the led will turn on solid green for 3 seconds and then off when programmed...

  • Page 15

    Rev.: 20121128 platform: dball firmware: ford1 © 2012 directed. All rights reserved. Go to the next page to complete the module programming. Note that 2 keys are required to complete the programming . Refer to the led diagnostics section on page 19 for more information and for troubleshooting purpos...

  • Page 16

    Rev.: 20121128 platform: dball firmware: ford1 © 2012 directed. All rights reserved. 6 7 the led turns on solid green for 3 seconds, then turns off once the module has been successfully programmed. Release the programming button. & off 5 the led now flashes orange, otherwise repeat steps 4 and 5. Wa...

  • Page 17

    Rev.: 20121128 platform: dball firmware: ford1 © 2012 directed. All rights reserved. Page 17 key2go & 1key programming you have successfully completed the key2go and 1key programming sequence. 2 open an internet explorer browser (version 6 or higher), and go to www.Xpresskit.Com. The detail of the p...

  • Page 18

    Rev.: 20121128 platform: dball firmware: ford1 © 2012 directed. All rights reserved. Module reset page 18 2 solid & solid flashes & release 3 wait 3 seconds until the led turns on solid orange, and wait 10 more seconds until the led starts to flash orange and red. Release the programming button. The...

  • Page 19

    Led status description troubleshooting module programming solid red module is powered and waiting for programming to begin. Verify your power lines (d2d or w2w). Solid green for 3 seconds module has been successfully programmed. Normal operation. Flashes orange two keys have been detected (key2go, i...

  • Page 20

    For a period of one year from the date of purchase of a directed electronics remote start or security product, directed electronics. (“directed”) promises to the original purchaser, to repair or replace with a comparable reconditioned piece, the security or remote start accessory piece (hereinafter ...