Xpresskit DBALL Installation Manual - page 18
Rev.: 20121128
Platform: DBALL
Firmware: FORD1
© 2012 Directed. All rights reserved.
Module Reset
Page 18
2
Solid
&
Solid
Flashes
&
Release
3
Wait 3 seconds until the LED turns ON solid orange, and wait 10 more seconds
until the LED starts to flash orange and red.
Release the programming button. The LED turns ON solid red.
Warning Against Executing a Hard Reset!
A hard reset will erase all the data stored in the DBALL and will change all the settings configured on the module to its
default values. After a hard reset, you may have to reconfigure your DBALL if your installation requires specific options,
not part of the default configuration.
1
OR
If required for your installation, connect the 10-pin, 12-pin &
14-pin harnesses to the module. Press and hold the
programming button, then connect the 4-pin D2D harness.
D2D Installation
If required for your installation, connect the 10-pin & 12-pin
harnesses to the module. Press and hold the programming
button, then connect the 14-pin harness to the module.
W2W Installation
10-p
in
D2D
st
1
12-p
in
14-p
in
nd
2
th
4
rd
3
10-p
in
D2D
st
1
th
5
12-p
in
14-p
in
nd
2
rd
3
th
4
Hard Reset
2
&
&
Solid
Solid
Release
Wait 3 seconds until the LED turns ON solid orange then release the
programming button. The LED then turns ON solid red.
A module reset will erase the module programming only (bypass, convenience and vehicle detection). All the settings
configured on the module using the web config tool will remain untouched.
1
OR
If required for your installation, connect the 10-pin, 12-pin &
14-pin harnesses to the module. Press and hold the
programming button, then connect the 4-pin D2D harness.
D2D Installation
If required for your installation, connect the 10-pin & 12-pin
harnesses to the module. Press and hold the programming
button, then connect the 14-pin harness to the module.
W2W Installation
10-p
in
D2D
st
1
12-p
in
14-p
in
nd
2
th
4
rd
3
10-p
in
D2D
st
1
th
5
12-p
in
14-p
in
nd
2
rd
3
th
4
4
5
Insert the key and turn it to the IGN position ON and OFF
two (2) times, LED will flash orange.
Unplug module and reconnect to xpresskit.com and follow
Key2Go instructions (bottom right).
&
Key at IGN
O
F
F
START
IG
N
6
Once completed, plug module back into vehicle. LED will be
solid green 3 sec and go out.
&
Off
Solid
Flashes Orange