Xpresskit DBALL Installation Manual - page 6
Rev.: 20121128
Platform: DBALL
Firmware: FORD1
© 2012 Directed. All rights reserved.
Page 6
Disarm Testing
(Read through all steps before proceeding)
2
5
4
Arm the factory alarm on your vehicle.
Position the key next to the ignition barrel in a way that you can free your
hands, and have a few jumpers ready for the next steps.
Note: This testing is to be done if you want to use the DBALL to disarm the factory alarm on unlock and trunk release
(Installation Type 2). This install type can only be done on low current ignition switch and on vehicles that do not disarm using
the key to unlock the driver's door. If using a one-button system or door locks are not being connected, the disarm will
automatically be done upon remote start.
3
Trigger the factory alarm by opening a door.
Arm Factory Alarm
Open Door
to Trigger
Alarm
Key OUT
O
F
F
START
IG
N
Key Near the Ignition Barrel
You must now try to power up the ignition, accessory and keysense wires with jumpers in order to
determine what is required to disarm the system. It can be a combination of two wires.
Note: The key must be near (
) the ignition barrel during the entire length of the
testing.
Common scenarios include Ignition only, Ignition + Accessory or Ignition + Keysense, but may differ.
but not inserted into
When you have found what combination works to disarm the system, refer to the
installation wiring diagram to make the proper connections to the DBALL module.
Warning: For ignition,
Brown/Red must be used or DBALL could be
damaged.
pin 12
Connect DBALL
1
4
5
Insert the key and turn it to the IGN position ON and OFF
two (2) times, LED will flash orange.
Unplug module and reconnect to xpresskit.com and follow
Key2Go instructions (bottom right).
&
Key at IGN
O
F
F
START
IG
N
6
Once completed, plug module back into vehicle. LED will be
solid green 3 sec and go out.
&
Off
Solid
Flashes Orange