Xpresskit DBALL Installation Manual - page 15
Rev.: 20121128
Platform: DBALL
Firmware: FORD1
© 2012 Directed. All rights reserved.
Go to the next page to complete the module programming.
Note that 2 keys are required to complete the programming
.
Refer to the LED Diagnostics section on page 19 for more information and for troubleshooting purposes.
(for Key2Go see page 17)
3
4
Insert the first key and turn it to the IGN position, wait at least
3 seconds but no more than 10 seconds, then remove it.
Insert the second key and turn it to the IGN position, wait at
least 3 seconds but no more than 10 seconds, then remove it.
&
&
Type 2 Module Programming
Key at IGN
1st Key IN
O
F
F
START
IG
N
Key at IGN
2nd Key IN
O
F
F
START
IG
N
Page 15
1st Key OUT
O
F
F
START
IG
N
Key out after 3-10 secs
2nd Key OUT
O
F
F
START
IG
N
Key out after 3-10 secs
Important
Make all the required connections to the vehicle, as described in the wiring diagram(s) found in this guide, and double check to
ensure everything is correct prior to moving onto the next step.
To take advantage of advanced features, you must use XpressVIP 4.5 or higher. Using version 2.9 or 3.1 will limit
available functions and features.
1. Connect the interface module to your computer using the XKLoader2.
2. Open an Internet Explorer browser (version 6 or higher), and go to www.xpresskit.com. The detail of the platform and firmware
that is currently saved on the interface module will be indicated in the top left corner of the page.
3. Select the year, make and model of the vehicle; the page will refresh to display the compatible firmware.
4. In the search result page, select one of the available install options (config for RSR, RXT or Standard install), and follow the
instructions provided on the screen.
5. Once you have configured your options, click on the FLASH button to upload the firmware onto the interface module.
6. The following message will be displayed when the upload is completed:
“The flashing is successfully completed. You may now unplug the kit.”
You can now proceed with the programming instructions below.
Warning!
2
Solid
Wait until the LED turns ON solid red.
1
OR
If required for your installation, connect the 10-pin, 12-pin
and 14-pin harnesses to the module, then connect the 4-pin
D2D harness.
D2D Installation
If required for your installation, connect the 10-pin and 12-pin
harnesses to the module, then connect the 14-pin harness to
the module.
W2W Installation
10-p
in
D2D
st
1
12-p
in
14-p
in
nd
2
rd
3
10-p
in
D2D
st
1
th
4
12-p
in
14-p
in
nd
2
rd
3
4
5
Insert the key and turn it to the IGN position ON and OFF
two (2) times, LED will flash orange.
Unplug module and reconnect to xpresskit.com and follow
Key2Go instructions (bottom right).
&
Key at IGN
O
F
F
START
IG
N
6
Once completed, plug module back into vehicle. LED will be
solid green 3 sec and go out.
&
Off
Solid
Flashes Orange