Xpresskit DBALL Installation Manual - page 17
Rev.: 20121128
Platform: DBALL
Firmware: FORD1
© 2012 Directed. All rights reserved.
Page 17
Key2GO & 1KEY Programming
You have successfully completed the Key2GO and 1KEY programming sequence.
2
Open an Internet Explorer browser (version 6 or higher), and go to www.xpresskit.com. The detail of the
platform and firmware that is currently saved on the interface module will be indicated in the top left corner
of the page.
1
3
5
8
4
7
6
Connect the DBALL module to your computer using the XKLoader2.
Flash your module with the firmware corresponding to FORD1 Key2GO.
Insert your key into the ignition barrel, then turn it ON and OFF twice. The LED starts flashing orange,
indicating that it is ready for the next step.
Once the configuration is completed, reconnect the DBALL to the vehicle. The LED flashes once orange,
and then turns ON solid green for 3 seconds.
Connect the DBALL wiring to the vehicle first, and only then, plug the harnesses to the DBALL without
pressing the programming button. The LED turns ON solid red.
Select the method and click on Submit Key2Go Request.
Remove the DBALL from the vehicle and reconnect it to your computer. The XpressKit web site will
automatically recognize that you are moving onto the second phase of the programming sequence.
Refer to the LED Diagnostics section on page 19 for more information and for troubleshooting purposes.
Version 4.5 or higher of XpressVIP must be installed on your computer to complete this programming sequence.
Method 2 (using 1 key)
4
5
Insert the key and turn it to the IGN position ON and OFF
two (2) times, LED will flash orange.
Unplug module and reconnect to xpresskit.com and follow
Key2Go instructions (bottom right).
&
Key at IGN
O
F
F
START
IG
N
6
Once completed, plug module back into vehicle. LED will be
solid green 3 sec and go out.
&
Off
Solid
Flashes Orange