Xpresskit DBALL Installation Manual - page 8
Installation Type 2 - Vehicles with Factory Alarm
(-) GWR (Status)
9:Pink: (+) Ignition Input
10:Blue/White: (-) GWR (Status) Input
3 Red/White: (-) Trunk Input
2 Blue: (-) Unlock Input
13:Red: (+) 12v
(+) 12v
14:Black: (-) Ground
10: Yellow/Black: TX
11: Yellow/Red: (+) 12v
11: Orange/Black: RX
12: Brown/Red: (+) Ignition (Disarm) Output *
7: Gray/Black: (+) Keysense/Accessory
Output *
(Disarm)
Passive Anti-Theft Security System (PATS) connectors (connector side view)
See the Vehicle Application Guide on page 2 and 3
Ignition
Ground
TX
RX
2
Ignition
Ground
RX
TX
3
TX
RX
Ground
Ignition
4
1
2
3
4
RX
TX
Ignition
Ground
1
Page 8
Not required in D2D mode.
Wires are listed by pin numbers. This display is not representative of connector pin layouts, which are often stacked.
* These outputs are for disarming upon unlock and trunk release, refer to page 6 for more information.
1
0
DBALL
RF
Programming button
LED
4
1
4
1
2
2
XKD2D65
TX
(-) Ground
RX
(+)12v
Rev.: 20121128
Platform: DBALL
Firmware: FORD1
© 2012 Directed. All rights reserved.
(+) 12v
(-) Ground
(-) Ground
(+) 12v
Parking lights
(+) Start
(-) Unlock
(-) Trunk
(+) Accessories (might be more than 1 for certain vehicles)
Hood pin
Ignition
R
e
m
o
te
S
ta
rt
e
r
Connect to Vehicle
Go to www.directechs.com
for more information
on vehicle-specific
wiring connections.
see pages 10 and 12 for color codes
WARNING!
Do not connect the
Keysense/Accessory
Output to the ignition
wire of the vehicle,
damage to DBALL
may occur.
4
5
Insert the key and turn it to the IGN position ON and OFF
two (2) times, LED will flash orange.
Unplug module and reconnect to xpresskit.com and follow
Key2Go instructions (bottom right).
&
Key at IGN
O
F
F
START
IG
N
6
Once completed, plug module back into vehicle. LED will be
solid green 3 sec and go out.
&
Off
Solid
Flashes Orange