Xpresskit DBALL2-MRC01 User Manual - Security
Page 3
Installation Wiring Diagram
Security
System
10
DBALL
Programming button
LED
1: Green: (-) Lock Input
2: Blue: (-) Unlock Input
3: Red/White: (-) Trunk Release Input
4: White/Violet: (-) AUX1 Input*
5: Violet/Black: (-) AUX2 Input*
4
TX
(-) Ground
RX
(+)12v
14
12
2
(+) 12v
5: Orange/Green: FT CAN High
3: Tan/Black: HS CAN High
6: Orange/Brown: FT CAN Low
4: Tan: HS CAN Low
13: Red: (+) 12v
14: Black: (-) Ground
7: Gray/Black: (+) Ignition Output
12: Blue/Red: (-) Hood Status Output
(+) Ignition Input
(-) Hood Status Input
3: Green/White: (-) Door Status Output
4: Red/Black: (-) Trunk Status Output
(-) Ground
RF Loop connector
(+) 12 V
(-) Ground
(-) Lock Output
(-) Unlock Output
(-) Trunk Release Output
(-) Trunk Status Input
(-) Door Status Input
Aux 1 Output
Aux 2 Output
See VAG
on page 2
Type B
Type A
OR
P#: XKD2D65
Not required in D2D mode.
Wires are listed by pin numbers. This display is not representative of connector pin layouts, which are often stacked.
* See Feature and Option list to know Auxiliary Channel programming options
Twisted pair in driver kick panel or
driver side under dashboard
(see page 4 for CAN location)
CAN High: Brown/Red
CAN Low: Brown
7: Pink/White: (+) Parking Lights Input
(+) Parking Lights Output
Rev.: 20150626
Platform: DBALL2
Firmware: MRC01
© 2014 Directed. All rights reserved.
&
Flashes
IGN
START
OFF
KEY
Key at IGN
IGN
START
OFF
KEY
Remove Key
Module reset will be done automatically upon programming.
2
When the LED turns ON orange release the IPB.
The LED turns ON red.
&
&
Solid Orange
Solid Red
Release
5
4
Turn the Ignition OFF
&
3 Sec
Off
Wait until the LED turns ON solid green for 3 seconds, then turns OFF.
The module has been successfully programmed.
Refer to the LED Diagnostics section on page 7 for more information and for troubleshooting purposes.
3
Turn the Ignition ON using Key or PTS
IGN
START
OFF
KEY
Remove Key
IGN
START
OFF
KEY
Key at IGN
&
Flashes
1
Connect the 10-pin & 12-pin harnesses to the module.
Press & hold the Integrated Programming button (IPB),
then connect the 4-pin D2D (only in D2D) & 14-pin harness
to the module (in D2D & W2W).
10-pin
D2D
st
1
th
5
12-pin
14-pin
nd
2
rd
3
th
4
Press Twice Push-to-Start (PTS) to turn the Ignition ON
START
STOP
START
STOP
E
E
N
N
GI
E
E
N
N
GI
x2
x1
or
or