Yaesu FTM-350R - SOFTWARE UPDATE PROCEDURE 7110 Operating Manual - Ftm-350R O
FTM-350R O
PERATING
M
ANUAL
13
B
AND
S
COPE
O
PERATION
E
NHANCED
M
ODE
You may perform the enhanced band scope operation while mono-band operation, when
expand the function of the Band Scope by the “Special Function” mode.
Switching to the Enhanced Mode
1. Turn the radio off.
2. Turn the radio on while press and holding the key which is located at the left of
the [POWER] switch to enter the “Special Function” mode.
3. Rotate the left side [DIAL] knob to select the function menu item “8 BAND
SCOPE”.
4. Press the left side [DIAL] knob, then rotate the left side [DIAL] knob to select
“SPECIAL”.
5. Press the left side [DIAL] knob to save the new setting.
6. Press the [ESC] key, the FTM-350R is reset automatically.
1
Rotate the “Main” band’s [DIAL] knob to tune the operating frequency.
2
Rotate the “Sub” band’s [DIAL] knob to move the cursor (S).
3
Press the [C=CSR] key to return the cursor to band center.
4
Press the [SCSR] key, replace the “S” cursor to “U”. In this case, you may tune the
operating frequency with the cursor together by rotating the “Sub” band’s [DIAL] knob.
5
Press the [C=CSR] key to return the current frequency and cursor to both band center,
and replace the “U” cursor to “S”.
1
4
3
5
2
FCC ID: K6620335X40
IC: 511B-20335X40