Yaesu FTM-350R - SOFTWARE UPDATE PROCEDURE 7110 Operating Manual - Ftm-350R O
FTM-350R O
PERATING
M
ANUAL
16
VFO S
CAN
1. Press the [F] key repeatedly until the [SMART FUNCTION] key’s category replaces
to “F-1”, then set the “Main” band to VFO mode by pressing the [V/M] key on the “F-
1” category, if necessary.
2. Press the [F] key briefly to change the [SMART FUNCTION] key’s category to “F-
2”.
3. Press the [SCAN] key on the “F-2” category to initiate the VFO scan.
3. Press the [SCAN] key again to stop the VFO scan.
You may customize the functions of the VFO Scan via following Set Mode items “F02
SCAN DIRECTION”, “F03 SCAN RESUME”, “F04 SCAN STOP BEEP” in the
“SCAN” group, and “G08 RX COVERAGE” in the “SYSTEM” group.
M
EMORY
S
CAN
1. Press the [F] key repeatedly until the [SMART FUNCTION] key’s category replaces
to “F-1”, then set the “Main” band to memory mode by pressing the [V/M] key on the
“F-1” category, if necessary.
2. Press the [F] key briefly to change the [SMART FUNCTION] key’s category to “F-
2”.
3. Press the [SCAN] key on the “F-2” category to initiate the memory scan.
4. Press the [SCAN] key again to stop the memory scan.
You may customize the functions of the Memory Scan via Set Mode items “D03 MEMORY
SCAN TYEP” in the “MEMORY” group, “F04 MEMORY SKIP/SELCT”, “F03 SCAN
RESUME”, “F04 SCAN STOP BEEP” in the “SCAN” group, and “G08 RX COVER-
AGE” in the “SYSTEM” group.
S
CAN
O
PERATION
FCC ID: K6620335X40
IC: 511B-20335X40