Yaesu FTM-350R - SOFTWARE UPDATE PROCEDURE 7110 Operating Manual - Ftm-350R O
FTM-350R O
PERATING
M
ANUAL
14
CTCSS/DCS/EPCS O
PERATION
CTCSS O
PERATION
1. Press and hold in the [F] key for two seconds to replaces the [SMART FUNCTION]
key’s category to “SQL”.
2. Press the [TYPE] key repeatedly, until the “TONE SQL” notation appears; this acti-
vates the CTCSS operation.
3. Press the [TyFRQ] key, then rotate the “Main” band’s [DIAL] knob to select the de-
sired CTCSS frequency.
4. Press the [ESC] key to save the new setting and exit to normal operation.
5. To finish the CTCSS operation, press the [TYPE] key repeatedly, until the “OFF”
notation appears.
You may customize the CTCSS operation so that a ringing “bell” sounds alerts you taht a
call is coming in via Set Mode item “J01 BELL RINGER” in the “SIGNALING” group.
See page 40 for details.
DCS O
PERATION
1. Press and hold in the [F] key for two seconds to replaces the [SMART FUNCTION]
key’s category to “SQL”.
2. Press the [TYPE] key repeatedly, until the “DCS” notation appears; this activates the
DCS operation.
3. Press the [DyCOD] key, then rotate the “Main” band’s [DIAL] knob to select the de-
sired DCS code.
4. Press the [ESC] key to save the new setting and exit to normal operation.
5. To finish the DCS operation, press the [TYPE] key repeatedly, until the “OFF” nota-
tion appears.
You may customize the DCS operation so that a ringing “bell” sounds alerts you taht a call
is coming in via Set Mode item “J01 BELL RINGER” in the “SIGNALING” group. See
page 40 for details.
FCC ID: K6620335X40
IC: 511B-20335X40