Yale Real Living Installation And Programming Instructions - page 6
6
An ASSA ABLOY Group brand
P/N AYRD220-INST-FUL Rev C
1. Install bolt in door.
NOTE: The bolt must be in a retracted (unlocked) position
when installing the lockset.
Attach with two (2) M4 x 25.4mm [8-32 x 1"] screws supplied.
2. Install strike on the door frame, making sure to allow
for the bolt to be centered in the strike.
INSTALL LOCK
(2) M4 x 25.4mm
[8-32 x 1"]
Flat Head
Combination Screws
(2) M4 x 25.4mm
[8-32 x 1"]
Flat Head
Combination Screws
1
2
3. Install outside escutcheon.
As you position the outside escutcheon, route the
wire harness through 2-1/8" diameter hole (Figure 3A).
NOTE: Wire harness goes under bolt (Fig. 3B).
Figure 3B
5. Secure both assemblies using (2)
M6 x 59.5mm pan head machine
screws (Fig. 4B), making sure that
outside escutcheon is vertically
aligned. Hand-tighten until snug.
Do not over-tighten.
Inside of Door
Figure 4B
Figure 4A
“Tongue”
Inside of Door
4. Holding the outside escutcheon flush to the door,
position the inside mounting plate by first routing the
wire harness through the mounting plate's 1/2" hole
(Fig. 4A), then inserting mounting plate “tongue“ into
groove at bottom of outside escutcheon.
Figure 3A