Yamaha CRX-330 Owner's Manual - Troubleshooting
29
En
Engl
ish
ADDITIONAL
INFORMATION
Refer to the table below when this unit does not function properly. If the problem you are experiencing is not listed below
or if the instruction below does not help, turn off this unit, disconnect the power cable, and contact the nearest authorized
Yamaha dealer or service center.
TROUBLESHOOTING
General
Problem
Cause
Remedy
See
page
This unit fails to
turn on or enters
the standby mode
soon after the
power is turned on.
The power cable is not connected or the plug is not
completely inserted.
Connect the power cable firmly.
This unit has been exposed to a strong external
electric shock (such as lightning or strong static
electricity).
Set this unit to the standby mode, disconnect the
power cable, plug it back in after 30 seconds and
then use it normally.
—
No sound
No appropriate input source has been selected.
Select an appropriate input source with the INPUT
on the front panel (or the input selection keys on the
remote control).
—
Speaker connections are not secure.
Secure the connections.
The volume is turned down.
Turn up the volume.
—
Signals this unit cannot reproduce are being input
from a source component, such as a CD-ROM.
Play a source whose signals can be reproduced by
this unit.
—
Sound is heard
from the speaker
on one side only.
Incorrect cable connections.
Connect the cables properly. If the problem persists,
the cables may be defective.
There is noise
interference from
digital or radio
frequency
equipment.
This unit is too close to the digital or high-
frequency equipment.
Move this unit further away from such equipment.
—
DAB reception
Problem
Cause
Remedy
See
page
Cannot tune into
any DAB stations.
The initial scan operations were not performed.
Perform the initial scan operations
There is no DAB coverage in your area.
Check with your dealer or WorldDMB online at
http://www.worlddab.org for a listing of the DAB
coverage in your area.
—
The DAB signals are too weak.
Use the TUNE AID feature to locate the best
positioning of the indoor DAB/FM antenna.
The initial scan
operations are not
successful and
“Not found”
appears on the
front panel display.
The DAB signals are too weak.
Use the TUNE AID feature to locate the best
positioning of the indoor DAB/FM antenna.
There is no DAB coverage in your area.
Check with your dealer or WorldDMB online at
http://www.worlddab.org for a listing of the DAB
coverage in your area.
—
The DAB station
reception is weak.
The positioning of the indoor DAB/FM antenna
and/or this unit is not optimal for DAB reception.
Use the TUNE AID feature to locate the best
positioning of the indoor DAB/FM antenna and this
unit for optimal DAB reception
The DAB signals are too weak.
Use the TUNE AID feature to locate the best
positioning of the indoor DAB/FM antenna.