Yamaha LS9 Editor Installation Manual - Network Settings
LS9 Editor Installation Guide
6
When you connect the computer to the LS9 directly
• Settings of the LS9
You can use the following initial settings.
• Settings of the computer
We recommend that you make the following settings.
When you connect the computer to the LS9 via LAN
Make the network settings of the LS9 and your computer in accordance with your LAN. Please contact your
network administrator for further detail. Also, please refer to “Caution for connecting LS9 to LAN” in the “Technical
Documents” section on the following web site:
http://www.yamahaproaudio.com/downloads/documents/
• Settings of the LS9
Network Settings
IP address
192.168.0.128
Gateway address
192.168.0.1
Subnet mask
255.255.255.0
IP address
192.168.0.3
Subnet mask
255.255.255.0
Default gateway (Router)
192.168.0.1
IP address
Sets the IP address so that it does not conflict with the IP address of any other device on
the network.
Gateway address
Set the IP address of the gateway when the gateway exists. Set the vacant address
when the gateway does not exist. The address should be set in the same subnet as IP
address within LAN in which the subnet is set.
Subnet mask
Set the subnet mask of the subnet connected to the LS9.