Yamaha MMP1 Setup Manual - 3. Used Equipment List

10 

3. Used Equipment List 

The main devices used in this guide are as follows:

1. Yamaha 

MMP1  

2.  Dante audio interface (Yamaha Nuage I/O) 

3.  Dante PCIe card (Yamaha Dante Accelerator) 

4.  Monitor speakers (3 sets x Yamaha HS series) and a subwoofer (HS8S) 

5.  Mic preamp (Yamaha MLA8) 

6.  Network switch (Yamaha SWP1) 

7. Cough 

box 

8.  4x headphone amp (3 for Cue, 1 for Control Room) 

9. VU 

meter 

10. Main computer (computer for DAW) 

11. Sub computer (computer for configuration software) 

12. Apple iPad (for configuration app) and adapter (for wired connection) 

13. Wifi access-point (Apple AirMac Extreme, for wireless connection) 

14. 6x microphone (4 for audio recording + 2 for talkback) 

15. External DC power supply for MMP1 

1. Yamaha 

MMP1 

http://www.yamahaproaudio.com/global/en/products/processors/mmp1/

In this example, MMP1 works as a signal processor, with which mic input signals are 

processed by using Channel Strip function and sent to the DAW via Dante, and also as a 

matrix mixer, the playback signals from DAW is routed to each speaker and headphone, 

either from local analog/AES/EBU outputs or from Nuage I/O (explained later) via Dante. 

Also, as a monitor controller, MMP1 switches between monitor sources, adjust the volumes 

and manages cue and talkback.