Yamaha Portatone PSR-5700 Advanced Features - page 56
56
+
–
+
–
¢MULTI PART SETTING
‡
Part=1
Channel= 3
[F6] Utility & MIDI
+
–
+
–
†¢MULTI PART:1
Volume=99
00:Piano 1
4
MULTI PART SETTING
(Remote Control Mode Only)
Purpose:
Allows the receive channel, volume, and voice to be inde-
pendently specified for 8 separate “parts” to be controlled
from an external MIDI device.
In the DOC mode MIDI reception occurs via channels 1
through 10, and channel 15 (rhythm part). In the GM mode,
reception occurs on all channels regardless of these settings.
Procedure:
In the first display screen use the left [-] and [+] buttons to
select a part number (1 … 8) and the right [-] and [+] buttons
select the receive channel (1 … 16, Off) for that part.
In the second display screen the right [-] and [+] buttons
select the voice for the currently selected part number in the
second display screen, while the left [-] and [+] buttons set
the volume of the voice.
Notes:
Note that parts that are not required can be turned “OFF”
via the “Channel” parameter in the first display screen.
If the channel number of any part is set to the same chan-
nel number as a lower-numbered part, the “!OFF” display
will appear and that part will be turned off.
Any of the preset or custom voices can be specified via the
voice parameter in the second display screen.
If the basic receive channel is set to
“
All,
”
reception is disabled
on all multi part channels, and
“
!OFF
”
appears in place of the
multi part channel numbers.
DETAIL
DETAIL
+
–
+
–
MIDI SWITCH
‡
CtrlChg=ON
ProgChg=ON
+
–
+
–
† MIDI SWITCH
PitBnd=ON
Exclusive=ON
5
MIDI SWITCH
(Remote Control Mode Only)
Procedure:
Use the [
] and [
>
] buttons to switch between display
screens, and the [-] and [+] buttons below each parameter to
turn reception/transmission of the corresponding MIDI data
on or off.
Notes:
These “switches” can be used to determine how the PSR-
5700 responds to MIDI data received from external equip-
ment. If, for example, you don’t want the PSR-5700 voices
to be changed by program change messages received from an
external device, turn the program change switch “OFF.”
The same applies to transmission from the PSR-5700 —
turn off data that you don’t want to be transmitted to external
equipment.
In the DOC/GM mode, all control change data are trans-
mitted and received regardless of the settings on this page.
Purpose:
Allows reception and transmission of control change, pro-
gram change, pitch bend, and system exclusive data to be
independently turned on or off.