Yamaha VL Owner's Manual - ● Stage
VL Version 2
33
4. New Features & Parameters
● Stage
¯ 4 , 6 in Stereo Mode; 4, 6, 8, 10, 12 in Monaural Mode.
Sets the number of phase-shift “stages” used by the phaser effect. More stages
produce a more pronounced effect.
● Freq.
¯ 0.057 … 40.0 Hz.
Sets the speed of modulation and therefore the rate of phaser effect variation.
● Depth
¯ 0 … 100%.
Sets the depth of modulation. Higher values produce deeper modulation and there-
fore a more pronounced phaser effect.
● Offset
¯ 0 … 100%.
Sets the frequency range to which the phase effect is applied. The higher the value
the higher the frequency range affected by the phaser effect.
● Phase (Stereo Mode)
¯ -180.0 … 180.0 deg.
● Diffusion (Monaural Mode)
¯ off, on.
When the Stereo mode is selected, this parameter becomes “
Phase
” and sets the
phase different between the left and right channel phaser signals. The larger the value, the
greater the “spread” in the sound. A setting of “
0
” produces a centered effect.
When the Monaural mode is selected this parameter becomes “Diffusion” and
determines whether the effect has a stereo spread (“
on
”) or is a centered monaural signal
(“
off
”).
● FB Gain
¯ -100 … 100 %.
Determines the amount of effect-sound feedback returned to the input of the phaser
stage. Higher negative or positve values produce a more pronounced effect.
● Wet/Dry Balance
¯ 0 … 100 %.
Sets the balance between the direct (“dry”) and effect (“wet”) sound. Higher values
produce a greater proportion of effect sound in relation to direct sound.
EDIT