Z-Com AC-1028 Quick Start Manual - page 5
2.
Refer the below wiring diagram to connect each wire to IDC slot on the back of the Access Point.
-
Connect the brown wire of RJ-45 cable to the IDC slot
①
labeled brown.
-
Connect the brown/white wire of RJ-45 cable to the IDC slot
②
-
Connect the green wire of RJ-45 cable to the IDC slot
③
labeled green
-
Connect the green/white wire of RJ-45 cable to the IDC slot
④
-
Connect the orange wire of RJ-45 cable to the IDC slot
⑤
labeled orange.
-
Connect the orange/white wire of RJ-45 cable to the IDC slot
⑥
.
-
Connect the blue wire of RJ-45 cable to the IDC slot
⑦
labeled blue.
-
Connect the blue/white wire of RJ-45 cable to the IDC slot
⑧
Note:
Orient the AC-1028 with the LED located at the bottom.
3.
Use a wire cutter to cut the redundant wires if necessary.