Z-Com AC-1028 Quick Start Manual - page 8
Manual is about: In-Wall Access Point
of
12
To check whether the Access Point has connected to the AP controller successfully, please do the
followings:
1.
Make sure you connect the AP to the PoE injector/switch to the same subnet as AP controller.
2.
On your PC, open a Web browser window.
3.
In the browser, type https://192.168.1.1 and press
4.
When a security alert dialog box appears, click
OK/Yes
to proceed.
5.
When the login page appears, enter the following:
• Username: admin
• Password: password
6.
Click
Login
.
7.
Go to General > Wireless Switch Settings. Select Connect Wireless Switch Via IP and enter the IP
address of the controller. Click
Apply
to save the configuration.