Z-Wave ZME WALLC-S Manual - page 2
11-11-2014
manuals.zwaveeurope.com/make.php?lang=en&type=&sku=ZME_WALLC-S
http://manuals.zwaveeurope.com/make.php?lang=en&type=&sku=ZME_WALLC-S
2/8
Batteries
The unit is operated by batteries. Use only batteries of correct type. Never mix old and new batteries in the same device. Used batteries contain
hazardous substances and should not be disposed of with household waste!
Battery Type: 1 * CR2032
Installation Guidelines
On factory default state pushing any button for one seconds starts inclusion (red/green LED blinking fast). This behavior can be used to test the factory
default or exclusion state.
The device can be mounted on every dry and flat surface using either screws or double side adhesive. First the mounting base is fixed on the wall. Next
step the switch frame is placed on the 2 frame and the electronic insert is used to fix the frame to the mounting base as shown on the image. Finally the
switching paddle(s) are mounted on the electronic base.
For battery change, the switching paddle(s) need to be removed. The CR battery can be replaced by pushing the little nipple above the battery. The old
battery will slide out and the new battery is inserted until the nipple will hold it again.
The device can be operated in two different modes:
Operation Mode: This is the mode where the device is controlling other Z-Wave devices or is activating scenes.
Management Mode: The device is turned into the management mode by pushing all four buttons for 5 sec. A blinking green LED indicates the
management mode. In the management mode the buttons of the device have different functions. If no further action is performed, the device will
turn back to the normal mode after 10 sec. Any management action terminates the management mode as well.
In management mode the following actions can be performed:
Button 1 - Re-Inclusion/Exclusion: Every re-inclusion or exclusion attempt is confirmed by hitting this button. Any button press stops the mode as
well.
Button 2 - Send Node Information Frame and Wake up Notification. (see explanation below)
Button 3 - Factory Default Reset. After clicking on button 3 keep button 4 pushed for >4 seconds
Button 4 - Enter into Association mode to assign target devices to one of the four association. Refer to the manuals section about association for
more information how to set and unset association groups.
Factory Reset
The device can be set back to factory defaults without performing an exclusion process. Please executes the following steps: (1) Turn the device into
Management Mode, (2) click on Button 3, (3) keep button 4 pushed for 4 seconds.
Behavior within the Z-Wave network
I
On factory default the device does not belong to any Z-Wave network. The device needs to join an existing wireless network to communicate
with the devices of this network. This process is called Inclusion. Devices can also leave a network. This process is called Exclusion. Both processes
are initiated by the primary controller of the Z-Wave network. This controller will be turned into exclusion respective inclusion mode. Please refer to your
primary controllers manual on how to turn your controller into inclusion or exclusion mode. Only if the primary controller is in inclusion or exclusion
mode, this device can join or leave the network. Leaving the network - i.e. being excluded - sets the device back to factory default.
If the device already belongs to a network, follow the exclusion process before including it in your network. Otherwise inclusion of this device will fail. If
the controller being included was a primary controller, it has to be reset first.
Once the controller is turned into inclusion mode turn the Wall Controller into management mode and hit button 3. The device is excluded by
entering management mode and hitting button 3 when the controller is in exclusion mode. To include/exclude the device in the NWI mode turn the
Wall Controller into management mode and hit button 1.