Z-Wave ZME WALLC-S Manual - page 3
11-11-2014
manuals.zwaveeurope.com/make.php?lang=en&type=&sku=ZME_WALLC-S
http://manuals.zwaveeurope.com/make.php?lang=en&type=&sku=ZME_WALLC-S
3/8
Operating the device
Depending on the button mode and operating modes configured using the configuration parameters the key fob can be used in different ways.
Button modes:
4 Groups are controlled with single button (parameter 1/2 = 0) The four buttons 1-4 control one single control group each: 1->A, 2->B, 3->C, 4->D.
Single click turns devices in the control group on, double click turns them off. Click and hold can be used for dimming.
2 Groups are controlled with two buttons (parameter 1/2 = 1) The buttons 1 and 3 control the control group A (button on turns on, buttons turns
off), the buttons 2 and 4 control the control group B (button on turns on, buttons turns off). In case dimmers are controlled, holding down the larger
button will dim up, holding down the smaller button will dim down the load. Releasing the button will stop the dimming function.
4 Groups are controlled with two buttons and double click (parameter 1/2 = 2) This mode enhances the previous mode and allows to control two
further control groups C and D using double clicks.
Operating modes:
The devices supports 8 different operating modes - this means the kind of command sent out when pushing a button. Operating modes either directly
control other devices or they issue various scene activation commands to a central controller. Operating modes for direct device control are:
Direct Control of associated devices with On/Off/Dim commands (parameter 11...14 = 1). Devices are controlled using Basic Set On/Off
commands and SwitchMultilevel Dim Start/Stop. This mode implements communication pattern 7.
Direct Control of associated devices with only On/Off commands (parameter 11...14 = 2). Devices are controlled using only Basic Set
On/Off commands. On dimming Up event On is sent, on dimming Down Off is sent. This mode also implements communication pattern 7.
Switch All commands (parameter 11...14 = 3) In this mode a all neighbouring devices will receive SwitchAll Set On/Off command and
interpret it according to their membership in SwitchAll groups. This mode implements communication pattern 7.
Door Lock Control (parameter 11...14 = 7) This modes allows direct control (open/close) of electronic door locks using secure communication.
The mode implements communication pattern 7.
Operating modes for scene activation are:
Direct Activation of preconfigured scenes (parameter 11...14 = 5) Associated devices in an association group are controlled by individual
commands defines by Z-Wave command class ‘Scene Controller Configuration’. This mode enhances mode Direct Control of associated
devices with On/Off/Dim commands and implements communication patterns 6 and 7. Please turn the button mode to 'seperate' to allows
different scene id on every button.
Scene Activation in IP Gateway (parameter 11...14 = 4) If configured correctly the buttons can trigger a scene in a gateway. The scene