ZAAZ 20K User Manual - page 7
ZAAZMOVEMENT.COM
7
ASSEMBLY INSTRUCTIONS
1.
Remove all packaging. Place
the machine base in the desired
location and proceed with
assembly.
3.
Connect the cable visible from
the bottom of the post to the
base of the machine.
2.
Insert the long cable through
the center hole at the top of
the post. Pull the cable through
the bottom of the post until it
is visible from both the top and
bottom of the post. Tie a loose
knot at the top of the cable to
prevent it from falling into the
post.
4.
Affix the post to the base of
the machine with 4 bolts, using
the provided screwdriver or a
12mm socket wrench. Tighten all
screws (begin with bottom pair)
3 or 4 turns only for the time
being, leaving the post flexible.
Note: When affixing the post
bolts, gently pull the wire slack
upwards from the top of the post
to prevent it from being pinched
inside the lip of the post.