ZAAZ 20K User Manual - page 8
8
ZAAZ
888.664.9229
5.
Unscrew the (2) screws on each
of (4) handlebar mounting points
on the base (2 on the left side of
the machine base, 2 on the right
side of the machine base).
6.
Remove screw from underside
of L-Shaped handle (A) and insert
handlebar into plastic coupling (C).
Re-insert screw through the plastic
coupling into the handle and tighten.
7.
Press lower handle piece (D)
into the socket of the plastic
connector (C).
9.
Put the left long handlebar onto
the top of the post. Insert screws
from the top of the arm through the
post and tighten firmly to the extent
that the screws are denting the metal
of the handlebar itself. Repeat steps
#6-9 for the right handlebar.
Note: When tightening the bolts,
ensure the wire is not being pinched.
A
B
C
D
8.
Put the two handle pieces
(B and D) onto the end tubes
simultaneously. Put screws In
loosely. Make sure all screw holes
line up before affixing handlebars
to the top of the post.
(Right handlebar shown)