Zadako Z1 User Manual - Notice !
Notice !
•
To set method of arming and disarming, it is possible to use only one from
allowed commands in one message KEY / RFID / RFIDN / ARM / DISARM .
Example: To set the control method write and send SMS message:
abcd
└─┘
KEY
RFID setup
When Car alarm receives SMS message with command RFIDN, it
activates reading mode. Subsequently, it is necessary to attach RFID tags to RFID
reader.
Reading of new tags must be done within 1 minute. Each reading of tag is signalized
by beep. It is possible to store maximum 4 tags. End of reading is signalized by
double beep. It is recommended to repeat this setting in case of loss of the tag, for
security reasons.
NOTICE !
Each command RFIDN deletes the list of all previously defined tags.
Command RFID is used only for activation of disarming mode via RFID tag. If at
least one tag is defined, beeps of built in buzzer sounds, together with LED diode
blink. The number of them indicates the number of RFID tags stored in memory of
Car alarm. In case that none RFID tag is defined, reading activates ( like if command
RFIDN would be set )
NOTICE !
•
After arming is set, the departure time is activated, standardly set for 30
seconds (possible to change this setting). After this time is over, double
beep sounds, which indicates arming activation, while detection of
inclination is activated after next 15 seconds.
•
If disarming, while RFID mode is set, it is necessary - after inserting the
key in ignition box and turning to position 1 – to attach RFID tag to reader
within 15 seconds, otherwise alarm turns on. (Interval of 15 seconds can
be set for longer).
11