Intel socket lga 2011 v3/2011/1366/115x/775 cpus amd socket fm2/fm1/am3+/am3/am2+/am2 cpu & apus ver.150810 cnps11x performa+ user's manual to ensure safe and easy installation, please read the following precautions. Www.Zalman.Com.
2 .Com specifications precautions ■ this cooler must be used with a 120mm fan. ■ avoid inserting objects or hands into the fan while it is in operation to prevent product damage and injuries. ■ do not ingest the thermal grease, and avoid its contact with skin and eyes. If contact is made with skin, ...
3 .Com components common components amd clip intel components amd components - socket lga 2011 v3/2011/1366/115x/775 - stand off socket fm2/fm1/am3+/am3/am2+/am2 intel clip stand-off 3 thermal grease thermal grease [zm-stg2m] loaging block nuts bolts double-sided tape backplate manual cooler side ca...
4 .Com space requirements the cooler’s installation requires an unobstructed space of 94.5mm(width) 132mm(length) and 153.5mm(height) with the cpu as a central reference point. Please check if components such as odds and psu protrude into the required space. Air guide removal air guides on enclosure...
5 .Com the holes in the clip (as shown below) are matched to the “keys” on the heatpipe cover for secure clip installation. The holes in the clip (as shown below) are matched to the “keys” on the heatpipe cover for secure clip installation. Insert insert key key space requirements the cooler’s insta...
6 .Com 1 2 install the bolts to the backplate according to the socket type and secure them with side caps. ※ backplate is not needed for lga 2011 v3 / 2011 sockets. Socket 775 socket 115x socket 1366 socket 1366 / 115x installation peel off one side of the double-sided tape and attach it to the cent...
7 .Com socket 775 installation peel off the loading block cover and attach it to the backplate with the sticky side facing the center of the backplate. Peel off one side of the double-sided tape and attach it with the sticky side facing the loading block. Then, peel off the top cover. Double-sided t...
8 .Com m/b socket 2011 v3 / 2011 user fasten the four stand-offs to the motherboard. Backplate is not needed. Stand-off socket 1366 / 115x / 775 user attach the backplate assembly to the back side of the motherboard by aligning the nuts to the motherboard mounting holes. If you were unsuccessful at ...
9 .Com m/b please make sure that pwm control mode is activated in the motherboard’s bios settings. Caution connect the cooler’s 4-pin connector to the motherboard’s cpu fan header. Amd clip partially unscrew the four bolts located on the base of the cpu cooler. Then, insert the amd clips between the...
10 .Com take note of the orientation of the nuts and the side caps. Caution x o peel off the loading block cover and attach it to the backplate with the sticky side facing the center of the backplate. Peel off one side of the double-sided tape and attach it with the sticky side facing the loading bl...
11 .Com dismantle the cpu cooler retention bracket on the motherboard by unscrewing the four bolts located at each corner (method may vary; consult the motherboard manual for details). Be sure to keep the retention bracket so the stock cpu cooler can be used as a backup. M/b m/b peel off the loading...
12 .Com m/b connect the cooler’s 4-pin connector to the motherboard’s cpu fan header. Please make sure that pwm control mode is activated in the motherboard’s bios settings. Caution latch the fan fixing clips to the notches located on the sides of the heatsink. Note: it is often easier to latch the ...
