ZALMAN CNPS11X Performa+ User Manual - page 11
11
.COM
Dismantle the CPU cooler retention bracket on the motherboard by unscrewing
the four bolts located at each corner (method may vary; consult the motherboard
manual for details). Be sure to keep the retention bracket so the stock CPU cooler
can be used as a backup.
M/B
M/B
Peel off the Loading Block cover and attach it to the Backplate with the sticky
side facing the center of the Backplate.
M/B
Attach the Backplate assembly to
the back side of the motherboard by
aligning the Nuts to the
motherboard mounting holes.
If you were unsuccessful at first
attempt, you may continue
with the installation without the
Double-sided Tape as it is not a
necessary component.
Apply thermal grease just enough to thinly cover the CPU surface, then fasten
the Bolts to isntall the cooler.