Zanussi FI 4590 T Instruction Booklet - Maintenance

9

MAINTENANCE

Unplug the appliance before carrying out any 

maintenance operation.

Periodic cleaning

Clean the inside with warm water and bicarbonate 

of soda.

Periods of  non-use

If you are not using the appliance for any length of 

time, the following precautions should be taken: 

unplug the appliance; take all food out; defrost and 

clean the inside and all the accessories; leave the 

door ajar so that air can circulate inside in order to 

prevent unpleasant smells forming.

Replacing the interior light bulb

The light inside the refrigerator compartment is 

easy to get at through the opening in the light 

holder.

If the light does not go on when the door is open, 

check that it is screwed into place properly.

If it still does not light up, change the bulb.

The rating is shown on the light bulb cover.

Fig. 13

D025

SERVICING

If a fault occurs, check the following before calling 

the Servicing Department:

The light does not come on when you open the door.

Check that the bulb is powered. If the electricity 

supply is OK, replace the bulb.

The compressor does not work.

Check that it is powered. Check that the thermostat 

is in operative mode.

The compressor runs continuously.

The thermostat is set too high.

Traces of water on the bottom of the refrigeration 

compartment.

Check that the defrosting water discharge hole is 

not obstructed (Fig. 12).

If the fault persists after carrying out the above 

checks, call your nearest Servicing Centre.

For quick service it is important when telephoning 

to give the number of the model and the serial 

number, both of which can be found on the serial 

number plate inside at the bottom left of the 

appliance.