Summary of ZDM17301SA
Page 1
En zdm17301sa zdm17301wa user manual dishwasher.
Page 2: Safety Information
Contents safety information 2 safety instructions 3 product description 4 control panel 5 programmes 6 daily use 7 hints and tips 10 care and cleaning 11 troubleshooting 12 installation 14 technical information 15 subject to change without notice. Safety information before the installation and use o...
Page 3: Safety Instructions
• the ventilation openings in the base (if applicable) must not be obstructed by a carpet. • the appliance is to be connected to the water mains using the new supplied hose-sets. Old hose sets must not be reused. Children and vulnerable people safety • this appliance can be used by children aged fro...
Page 4: Product Description
Service centre to replace the water inlet hose. Use • do not sit or stand on the open door. • dishwasher detergents are dangerous. Obey the safety instructions on the detergent packaging. • do not drink and play with the water in the appliance. • do not remove the dishes from the appliance until the...
Page 5: Control Panel
Control panel 1 2 3 4 5 1 on/off button 2 display 3 delay start 4 programmes 5 start / pause indicators indicator description intensive programme normal programme eco programme rinse aid salt quick plus programme 20 min party programme glass programme www.Zanussi.Com 5.
Page 6: Programmes
Programmes programmes pro- gramme degree of soiling type of load phases in the cycle detergent pre-wash / main wash dura- tion (min) ener- gy (kwh ) wa- ter (l) rinse aid intensive heavy , dried-on soiling pans, pots, casserole dishes • pre-wash 50°c • wash 70 °c • rinse • rinse • rinse 70 °c • dryi...
Page 7: Daily Use
3. Press on/off button to activate the appliance. 4. To set a programme, press programmes until the indicator of the selected programme comes on. 5. Press start / pause to start the programme. Starting a programme with delay start 1. Close the appliance door. 2. Open the water tap. 3. Press the on/o...
Page 8
4. Remove the salt around the opening of the salt container. 5. Turn the cap of the salt container clockwise to close the salt container. Water and salt can come out from the salt container when you fill it which poses a risk of corrosion. To prevent it, start a programme immediately after filling t...
Page 9
Filling the detergent dispenser 1. Press the release button (a) to open the lid (b) of the detergent dispenser. A b 2. Put the detergent (approximately 15 g) in the compartment (c). The compartment has 2 parts (d) and (e) that refer to different quantities of detergent (15 g and 25 g). Put detergent...
Page 10: Hints and Tips
Fill the rinse aid dispenser when the rinse aid indicator on the display comes on. Adjust the rinse aid dosage factory setting: position 3. You can set the rinse aid dosage between position 1 (lowest dosage) and position 4 (highest dosage). Turn the rinse aid selector (h) to increase or decrease the...
Page 11: Care and Cleaning
Caution! Make sure that the spray arm can turn freely before you start a programme. Hints and tips • do not put in the appliance items that can absorb water (sponges, household cloths). • remove the remaining food from the items. • make soft the remaining burned food on the items. • put hollow items...
Page 12: Troubleshooting
Protecting against frost protect the appliance from frost, for example in winter. After each cycle: 1. Disconnect the appliance from the electrical supply. 2. Shut off water supply and disconnect the water inlet pipe from the water valve. 3. Drain water from the inlet pipe and water valve. 4. Connec...
Page 13
The washing and drying results are not satisfactory problem possible cause possible solution the dishes are not clean. The selected programme was not applicable for the type of load and/or for the degree of soil. Make sure that the programme is applicable for the type of load and/or for the degree o...
Page 14: Installation
Installation assembly make sure to position the appliance with minimum space of 50mm on both sides of fully open door. Keep 5 mm distance between both sides of the appliance and the cabinet. There are two possibilities for the cabinet hole for the appliance. Min. 550 mm min. 443mm 100 80 min. 555mm ...
Page 15: Technical Information
Final check the following things should be checked before starting the dishwasher. • the appliance is levelled and fixed properly. • the inlet valve is open. • inlet hose connections are fully tightened and not leaking. • the wires are tightly connected. • the power is switched on. • the inlet and d...
Page 16: Www.Zanussi.Com/shop
Www.Zanussi.Com/shop 100001022-a-172015.