Zanussi ZDM17301SA User Manual - page 13
The washing and drying results are not satisfactory
Problem
Possible cause
Possible solution
The dishes are not clean.
The selected programme was not
applicable for the type of load
and/or for the degree of soil.
Make sure that the programme is
applicable for the type of load
and/or for the degree of soil.
The basket was not loaded cor-
rectly, water did not reach all sur-
faces.
Load the basket correctly.
The spray arm could not turn
freely because of the incorrect
arrangement of the load.
Make sure that the spray arm can
turn freely before you start a pro-
gramme.
The filters are clogged.
Make sure that the filters are
clean.
The filters are not correctly as-
sembled and installed.
Make sure that the filters are cor-
rectly assembled and installed.
The quantity of detergent was not
enough or no detergent was
used.
Make sure that a correct amount
of detergent is used.
Scale particles on the dishes.
The salt container is empty.
Fill the salt container with specif-
ic salt for dishwashers.
The cap of the salt container is
not closed correctly.
Make sure that the salt container
is correctly closed.
There are streaks or milky stains
on glasses and dishes.
The level of the water softener is
too high.
Set the water softener to a lower
level.
There are bluish layers on
glasses and dishes.
The rinse aid dosage is too high.
Set the rinse aid dispenser to a
lower position.
The detergent can be the cause.
Try a different brand of detergent.
The dishes are wet and dull.
A programme without a drying
phase has been selected.
Set a programme with a drying
phase.
The rinse aid dispenser is empty. Fill the rinse aid dispenser with
rinse aid.
Error codes
Code
Meaning
Possible cause
E1
Longer inlet time
Tap is not open or water intake is
restricted or water pressure is
too low
E4
Overfilled
Too much inlet water or some
dishwasher element leaks
www.zanussi.com
13