Zanussi ZDM17301SA User Manual - Installation
Installation
Assembly
Make sure to position the appliance
with minimum space of 50mm on
both sides of fully open door.
Keep 5 mm distance between both sides of the
appliance and the cabinet. There are two
possibilities for the cabinet hole for the
appliance.
min.
550 mm
min.
443mm
100
80
min.
555mm
1
Power cord, drain hose and water supply
line hole. To facilitate a proper installation,
position the hole to the right or the the left
of the appliance.
Electrical connection
WARNING!
Do not use an extension cord or and
adapter plug with this appliance.
WARNING!
Do not cut or remove the earthing.
WARNING!
Make the electrical connection with
the power cord.
For rating voltage check the rating
plate.
Water drain connection
max. 750 mm
• Connect the water drain hose into a drain
pipe with minimum diameter of 40 mm.
• Put the water drain hose directly into the
sink. use the special plastic support.
The water drain hose must be less than 750
mm from the bottom of the appliance to prevent
problems during the draining phases.
Remove the sink plug when the appliance
drains water to prevent that the water goes
back into the appliance.
The extension of the water drain hose must not
be longer than 2 m. The internal diameter must
not be smaller than the diameter of the drain
hose.
If you connect the water drain hose to a trap
spigot under the sink, remove the plastic
membrane (A). If you do not remove the
membrane, remaining food can cause a
blockage in the drain hose spigot.
A
14
www.zanussi.com