Zartek ZA-711 User Manual - page 14
Scan Add/Delete
You can add a channel to the scan group or delete it from group.
Add choose Yes in the channel row under the Scan Add column to add
the channel.
Del choose No in the channel row under the Scan Add column to remove
the channel.
Password Protecting Read Programming
The programming of the radio can be protected from reading using a 6
digit software password. Once a password is programmed and written to
a radio, the user must enter the password in the software before being
able to read the radio. If the password is forgotten, you must contact your
dealer to reset it. It is still possible to overwrite the programming as
normal as no password is required when writing only when reading.
Monitor Momentary
The squelch circuit on the transceiver mutes the speaker automatically,
when no signals are present. So you will not hear background noise.
Press the Monitor key to deactivate the squelch manually. This is useful
when you want to adjust the volume level, or when you need to hear a
weak signal. Monitor Momentary will remove squelch so all background
noise will be heard and all tones (QT/DQT) accepted on the same
frequency.
The LED indicator lights green while the radio is in Monitor mode.
SK1 is Factory programmed on Monitor Momentary
VOX (Voice-operated Transmission)
The ZA-711 has innovative state-of-the-art technology not seen in other
two-way radios with its multi-level sensitivity built-in VOX function. You
can enjoy talking and listening without pressing PTT key as transmit is
automatically activated by sound. This turns your radio into hands-free
“walk & talk” when used with a headset. Voice activation is used to
operate the radio in hands-free mode or as a noise / baby monitor.
will be totally private.
Scan
Either side key can be programmed to activate / deactivate this function.
The scan function is useful when you want to find other people on similar
frequencies or to monitor communication within your group. If an active
channel is found the scan will stop and lock on to that channel. You can
now transmit and receive on this frequency. When the signal is gone for 5
seconds, scanning will resume. The radio will announce which channel of
the possible 16 programmed channels has been received. This is very
useful when monitoring a large number of channels and responding to
the correct channel.
Priority Scan
Normal scan will sequence through all the channels in
order until a signal is detected. Priority scan allows
one channel to be checked more often which is useful
when there is one main or more busy channel.
For example: If CH2 is set as a priority channel. So
the scan method will be:
Normal scan is CH1, CH2, CH3, CH4……According
to the sequential scan.
Priority scan is CH1, CH2, CH3, CH2, CH4,
CH2…… checks same channel in between others.
Scan Modes
There are two modes of scanning depending on the user’s type of
communication.
Carrier: Scan will stop and lock when a signal is received and continue
scanning after the signal has gone for 5 seconds.
Time: Scan will stop when a signal is received and continue scanning 5
seconds later.