Zartek ZA-711 User Manual - page 8
Remove the Belt Clip
Unscrew both screws from the holes and
remove belt clip.
Install & Remove the headset /
programming cable
Open (unscrew) the SP / MIC cover and then
plug in the accessory firmly into the side
jack.
If you want to remove the accessory, unplug
it gently and close the SP/MIC cover.
Charging the Battery
When the battery capacity runs low, the radio’s red LED will
begin to flash and a voice message “Please charge the
battery” will be heard.
Only use the charger docking station and AC adaptor supplied
with the radio. The battery can be charged whilst it is fitted to
the radio or simply on its own as depicted in the sketch below.
Setup:
Please follow these steps:
1.If the battery is to be charged whilst fitted to the radio, please ensure
that the radio is switched off.
2.Connect the adaptor cable to the back of the desktop cradle.
3.Connect the adaptor to the AC power socket.
4.Insert the radio or the battery into the charger cradle. The Red and
Green LEDs will flash briefly.
5.The following LED display sequence will now show the status of the
charging process as depicted in the table below:
Continuous Red LED indicates that the battery is being charged. The
charging process will approximately take 5 hours.
When the battery is fully charged, the Red LED will change to a green
LED which will be ON continuously. Remove the AC power supply from
the charger pod or remove the Radio / battery from the cradle.
If the Red LED keeps flashing, the battery voltage is below 6V or the
battery could be damaged. If the battery voltage is below 6V, the
battery will eventually begin to charge after some time and the status of
flashing Red LED will change to being continuously ON. If however, the
battery is damaged, the status of the flashing Red LED will not change.
Charger Status:
NB Overcharging a battery can reduce its life. It is advisable to stop the
charging process when the green LED comes ON.
LED Status
Red and green light flash
for 1 second, then will go
out.
No light
Red light continuously
Green light continuously
Red light flash
Charger Pod Status
Power on
Standby Mode
Charging Mode
Full Charging
Fault
Remarks
No battery in charger
Battery voltage is lower
than 6V or damaged.