Zartek ZA-711 User Manual - page 7
No.
9
10
11
Unit
Side Key 2 (SK2)
SP/MIC Jack
Battery Pack
Remarks
SK2 is factory set on Battery level indicator
(short press) & High / Low Power adjust (long
press)
Dustproof and Rainproof
GETTING STARTED
Install & Remove the Battery
Installing Battery Pack
Align the battery pack with the grooves on the back
chassis of the radio.
Slide the battery pack along the chassis until it fits
into the top groove with a “Click”.
Removing Battery Pack
Push the battery pack latch inwards to unlock and
release the battery.
When the battery pack is released from the groove,
push the battery pack downward and remove it.
Install & Remove the Antenna
Install the Antenna
1.Switch off the radio; insert the threaded end of
the antenna into the antenna connector on the
top of the radio.
2.Screw down the antenna clockwise until it is
secure.
Remove the Antenna
Switch off the radio then turn the antenna
counter-clockwise to remove.
Install & Remove the Belt Clip
Install the Belt Clip
Remove the battery off the radio. Line up the
holes of the belt clip with those on the radio
and insert both screws. Tighten clockwise
using a screwdriver until secure.