Zavio D7210 Quick Installation Manual - page 5
4
Power Mode
PoE Mode
Power Requirement
PoE (IEEE802.3af) with Class 3
Power Consumption
4.19 W
Adaptor Mode
Power Requirement
12V/1A Adaptor
Power Consumption
4.24 W
Install the hardware and connect all cables
A. Hardware installation
1) Loosen the tamper-proof screws using supplied L-type hex key wrench and
remove the dome cover. Be careful not to scratch the dome cover.
2) You may feed the cables through the upper conduit hole or the side conduit
hole. Please use the supplied blind pug to seal the unused conduit hole.
3) Side conduit hole installation: Disassemble the cable gland first and feed the
network and I/O cable through the sealing nut, claw and cable gland. Connect
the cables to the camera. Attach the cable gland to the conduit hole. Push the
claw into the cable gland and tighten the sealing nut to secure the cables.
B. Wall and ceiling mounting
1) Attach the alignment sticker to the wall/ceiling. Drill three holes into the wall -
two for screws and one for cable.
2) Align the screw holes on the plastic base to the two plastic anchors on the
wall/ceiling, insert the supplied screws to the hole and secure them.
3) Secure the camera to the plastic plate with the screws (M2.5x6 * 2pcs)