Zavio V1100 User Manual - Ptz Setting
V1100 User Manual
16
PTZ Setting
Patrol Setting
You may set the speed of digital pan/tilt/zoom, and also speed for preset/patrol. The range goes
1-100(slow to fast).
Control Panel
This can be set up the selected view area in every profile. Besides the viewing window there is a PTZ
control panel to go to the direction you want.
Preset Position
In this section, up to 128 Pan / Tilt and Zoom positions can be saved, as well as the home position, which
the device faces to when the power is turned on.
Name your every position and give it a ranged
number(1~128) as an address, then click “add”, you can click “go” to make sure if the preset position
has been written in.
Guard Tour
Click “add” , name the tour first then add in the preset position you desired to form the tour. You can
manually set the PTZ speed and the interval time.
PTZ Control
Speed Control
Pan Speed:
Use it to move bar from 0 to 100.
Tilt Speed:
Use it to move bar from 0 to 100.
Auto Pan Speed:
Use it to move bar from 0 to 100.
Zoom Speed:
Use it to move bar from 0 to 100.
Focus speed:
Use it to move bar from 0 to 100.
RS-485 Setting
Protocol: Include Pelcop, Pelcod, Dynacolor, and Vtrec.
Note: If those Protocols aren’t supported by the device, please select “Custom” then click
“Custom Command” to customize the parameters via this page.
Custom Command
Custom Command Guard Tour Setting: Up to 10 custom commands are provided to setup
functions which are highly used.
Baud rate: Include 9600, 4800, 2400 and 1200.
Address: Type it from 0 to 128.
Focus: User may turn the focus from “Auto” to “Manual”.
Iris: User may turn the iris from “Auto” to “Manual”.