Zavio V1100 User Manual - Sd Card
V1100 User Manual
19
SD Card
Make sure to insert the SD Card first then click “on”. Create a folder name for event server in SD
Card. Optional selection for overwrite the previous file or not, if not, you may set a warning when
the capacity below the following percentage:5%, 10%, 25% and 50%.
Event List
Event List
General
Name the event file and make it on or off.
Trigger
You may activate the following trigger types as you wish depends on various conditions:
Motion Detection: Click it on for using Motion Detectionfunction as a sensor. You must
configure motion detection function before taking this as the trigger. Set minimum time interval
between 2 triggers, and choose the desired detection area. The detection type individually stands
for the following meanings:
Start: The trigger would be activated when the target object starts to move.
Stop: The trigger would be activated when the target object stops to move.
Start-Stop: The trigger would be activated during the target object starts to move till it stops.
Audio Detection: Click it on for using Audio Detectionfunction as a sensor. You must configure
audio detection function before taking this as the trigger. Set minimum time interval between 2
triggers. The detection type stands for the following meanings individually:
Start: The trigger would be activated when the sound being made.
Stop: The trigger would be activated when the
sound being cut off.
Start-Stop: The trigger would be activated during the sound being made and cut off.
Digital Input: This can be set to control the external alarm input of I/O port on the rear of the
device to start the trigger.
Periodical: This can be set the certain period (by minute) to start the trigger.
On boot: The event is triggered when the device has been started over.
Capacity Warning: This is triggered when SD Card capacity is be below the value you set.
Network Link Down: The event is triggered when the network gets disconnected.
IP Notification: The event is triggered when the network being restarted or the IP being
changed. And there are optional network types to select, such as DHCP、Static IP and PPPoE.