ZBA Z-3060 User Manual - 5. Setting Up The Scanner

5. Setting up the Scanner 

In certain cases no setup is required.  The scanner is either 

pre-programmed to suit the situation, or it automatically detects and is 

ready to go.    In other cases the scanner must be informed about what 

kind of system it is connected to.    This can be done in a few moments 

using the programming barcodes enclosed in the later sections of this 

booklet. 

The programming section may be used to set a number of parameters on 

the scanner: communication interface type (RS-232, Keyboard, USB), 

beep tone, sleep mode timings, same-code delay time, enable/disable 

decoding of numerous code types, and more advanced things like set 

headers and trailers. 

Individual parameters may be set at any time without affecting the other 

parameters. 

5-1. Scan Test 

1.  With the scanner running (LED blue) and the host system on, try to 

scan several known-good barcodes. 

2.  Check the results on the POS screen.  If the scanner is reading 

okay, no further setup may be necessary. 

3.  If the POS screen does not show the expected scans, go to Set Up, 

below. 

5-2. Set Up 

With the scanner running (LED blue) and the host system on, present the 

barcode, found in the programming section, to the 

scanner. The scanner gives two beeps: low and high, and the LED turn 

red.    The scanner is in programming mode. 

Decide which parameters are required and find their barcodes in the 

programming section. 

Cover unwanted codes with your hand and present the desired codes, 

one by one, to the scanner, the scanner beeps once as it accepts each 

code. 

7