ZBA Z-3060 User Manual - 6. Operating The Scanner

6. Operating the Scanner 

The scanner can read barcodes in either omnidirectional or single-line 

mode to accommodate different requirements.  This scanner is truly 

omnidirectional while single-line mode is usually used for better aiming on 

the specific barcode on the same sheet of more than one barcode printed 

closely.   

6-1. Function Button 

Press down the Function Button on top of the scanner    as shown below 

to switch between omnidirectional scanning and single-line scanning 

modes. 

Function Button 

¾

  If the scanner is powered off and re-turned on, even the 

function button is pushed down before it’s turned off, the 

scanner stays as factory default (omnidirectional scanning). 

Hence, in order to have single-line scanning, the function 

button has to be pressed up and pressed down again. 

1) Presentation Mode: 

As if the scanner is on the stand, the scanner will always stay active in 

Presentation Mode. In other words, no matter if the Function Button LED 

light is on or off, the scanner stays in the Presentation Mode. 

9