ZBA Z-3060 User Manual - 7. Maintaining The Scanner

7. Maintaining the Scanner 

The scanner is designed for long-term trouble-free operation and rarely 

requires any maintenance. Only an occasional cleaning of the scanner 

window is necessary in order to remove dirt and fingerprints. 

7-1. Cleaning the Scan Window 

Wipe the scan window with a soft lint-free cloth and a non-abrasive 

cleaner to avoid scratching and damaging the scan window.    The scan 

window may be cleaned while the scanner is running. 

7-2. Replacing the Interface Cable 

The standard interface cable is attached to the scanner with an 10-pin 

modular connector.    When the connector is properly seated, it is secured 

in the scanner handle by a flexible retention tab.    The cable is designed 

to be field replaceable. 

Replacement cables can be obtained from your authorized distributor. 

To replace the cable, take the following steps. 

1.  Make sure that the power of your computer is switched off, and if a 

power adapter is used, disconnect it from the scanner cable. 

2.  Disconnect the old scanner cable from the computer system. 

3.  Locate the small hole at the bottom of the scanner. (Shown as 

indicated) 

4.  Use a metallic pin and insert into the hole. 

5.  Gently pull out the interface while pressing down the hole by pin.  

The cable should come out. 

6.  Insert the new interface cable into the bottom of the scanner until it 

clicks. 

7.  Plug the new cable into the host. 

8.  If a power adapter is used, plug the power adapter into the jack on 

the interface cable. 

13