Zebora YSW15 Quick Setup Manual - page 10
10
Q: Why can’t I change camera settings?
A: Because your “Yoosee” is not connected with the camera. Only when the communication
of camera and Yoosee is in good condition, you can change the camera settings. Please
pull the page of device list to refresh.
Q: How can I delete the video if the SD card is full?
A: The SD card can be overwritten if it is full. You can also delete it manually. Turn off the
“Record Switch” in “Record Settings”, then go to “Storage info” to “formart/erase SD card”.
Q: The camera stops recording, and I can’t format the SD card either on Yoosee or computer,
why?
A: It is probably that your SD card is defective.
Q: My SD card is in the slot, why I cannot open “Storage info”?
A: Eject the SD card and insert again.
Q: Why the camra is video recording when I start monitoring on CMS?
A: Just click , and select “Close” for Auto start record when monitoring.
Part 3: About Camera Settings
Q: How can I change the camera password?
A: You can change it in “Settings>>Security Settings>>Admin password”. You can also set
a guest password, so that people can use this password to add your camera to view the
video, but they can’t change the camera settings.
Q: How can I side up the image if I install the camera on ceiling?
A: Just click “Settings>>Media Settings”, turn on “Images Reverse”.