Zebra CONCIERGE CC5000-10 Setup And Installation Manual - page 4
4
CONCIERGE CC5000-10
Figure 3.
Ports
Overview
The Concierge CC5000-10 is a pre-assembled system consisting of the following:
• 10.1 in. touchscreen display
• Concierge Main PCB, 8MP Camera, Speakers, Mic, Flash Memory, Network
Interface, Peripheral Ports
• Bar code scanner
• Bezel enclosure
• Associated pre-wired cabling.
The final system hardware configuration may change based upon customer
preference, including additional accessories (sold separately).
The final system mounting/installation is determined by the customer (e.g.,
mounting the system on a wall, on a stand, or within a customer designed
enclosure).
Ensure the mounting configuration allows end-users to easily interact with the
Concierge CC5000-10 touchscreen, and allows adequate space for end-users to
scan products using the bar code scanner.
Unpacking
Carefully remove the Concierge CC5000-10 from the packaging to avoid
damaging the touchscreen display. Once removed from its packaging, inspect the
device for damage.
Retain the packaging as it is the approved shipping container, and should be used
if the Concierge CC5000-10 needs to be returned for servicing.
Cleaning and Maintenance
• Always turn off the Concierge CC5000-10 before cleaning.
• The touchscreen surface may be cleaned using a soft clean cloth moistened
with mild window glass commercial cleaners.
• Use a soft cloth moistened with mild detergent to clean the display housing.
• Do not touch the display screen surface with sharp or hard objects.
USB Ports
Diagnostic Mode Buttons
RJ45 Ethernet Port,
PoE Enabled
Micro USB
OTG Port
Micro HDMI
Out Port
Activity
LED
MN001103A01a.fm Page 4 Monday, March 23, 2015 2:50 PM