Zebra EM220II Unified Mobile Utility Manual - page 11
EM220II
Rev. 1.00
- 11 -
Mobile Printer
Unified Mobile Utility Manual
7) After setting the desired function(s), click the
“Save” button to store settings.
The functions per category are as follows:
Function
Description
Printing Density
Sets printing density
Value range is 80~150%
Printing Speed
Sets printing speed
Value range is 50 or 90 mm/s
Default Code Page
Sets the default code page
(Refer to the Code Page Manual for more detailed information on
the Code Pages supported.)
Default Font Type
Sets default font type and size
Double Byte Character Mode
Sets double byte language usage mode
Printer Service
Printer Service change receipt mode or label mode.
Beeps for Paper Roll End
Sets no beeping or beeping when reaching paper roll end
Beeps for Low Battery End
Sets beeping when reaching low battery capacity
Auto Power Off Time
Sets time interval between absence of printer use and automatic
turning off of printer power
Auto Power Saving Time
Sets time interval for automatic entering into power saving mode
while the printer is in use
Black Mark Sensor
Sets using front or rear paper sensor(black mark sensor)
MSR Trigger
Sets MSR data scanning mode, 7 modes supported
(Refer to
“GS ( E” in the Control Commands Manual.)
RF Interface Configuration
Sets Wireless connection type (WLAN, Bluetooth)
Serial Interface Configuration
Changes the serial Interface setting
*Printer must be reset after change for changed setting to take
effect
Authentication & Encryption
Sets or cancels Authentication & Encryption mode when
connecting via Bluetooth
* If Authentication & Encryption mode is disabled, connection to a
device can be done without a PIN Code.
Connection Mode
Sets Mode1, Mode2, or Mode3 when connecting via Bluetooth.
- Mode1: connection possible only with the first device with which
connection succeeds
- Mode2: connection with all Bluetooth enabled devices possible
via use of a PIN Code
- Mode3: connection possible only with the first device with which
connection succeeds and searching or use of connected device
possible
PIN Code
Changes the PIN Code required for Bluetooth connections
(maximum 12 characters long)
Printer Name
Changes the device name produced when establishing a
Bluetooth connection (maximum 12 characters long)
* You can check authentication, Encryption mode as well as connection mode of the
Bluetooth from self test page.
8) Reset the printers.