Zebra QL Series User Manual - Charging The Battery

12

QL Series User Guide

Charging the Battery

LI 72 Single Battery Charger

Refer to Figure 3.  Your battery charger may look slightly dif-

ferent from the ones illustrated.

1. Install the battery in the printer and plug the Charger into

the appropriate A.C. wall receptacle.  Then insert the

charge cable into the battery charger jack.

2. The charger LED will indicate the status of the charger as

follows:

• A steady light indicates the battery is undergoing a fast

charge.

• A slow blinking light indicates the charger is in trickle

mode. The battery is ready for use.

• A rapidly blinking light indicates a problem with the

battery. The battery may have an internal short, or its

charge monitoring circuitry may be malfunctioning. The

battery should not be used any further.

• Battery Packs may be charged either when installed in the

printer or when removed.

 Do not attempt to charge batteries with the LI 72 while printing.

Attempting to print while charging can result in improperly

charged batteries.

LI72 Charger

Charger Jack

Figure 3: Single Charger