Zebra QL Series User Manual - Pcmcia Radio

33

QL Series User Guide

QL 320 Wireless Local Area Network (WLAN) Module Using

PCMCIA Radio

The following section only applies when the PCMCIA WLAN module (FCC ID: I28-

QL320352) is installed in the QL 320 printer (note that only one of the radio options

can be installed in the printer at one time). The FCC ID number label is on the front of

the module and can be read with the module installed.

 WARNING: Use of the QL 320 with the radio module marked

with FCC ID: I28-QL320352 meets the FCC requirements for radio

frequency (RF) radiation exposure in the standard body worn

configuration with no minimum separation. In this configuration,

which applies whether the belt clip or shoulder strap is used, the

face of the printer from which paper is transported is facing away

from the user’s body. The standard configuration must always be

used when the printer is body worn. This configuration maintains

the required 1 cm separation distance.

The printer with this radio option has been SAR tested. The

maximum SAR value measured was  .819 W/kg averaged over 1

gram.

European Regulatory Information for this Radio

AUS

B

DK

FIN

F

D

GR

IRE

I

LUX

NL

P

E

S

UK

Note: -Member states in the EU with restrictive use for this device are

crossed out!

This device is also authorized for use in all EFTA member states (

CH,

ICE, LI, NOR

)

Europe EU Declaration of Conformity

This device complies with the essential requirements of the R&TTE Directive

1999/5/EC.  The following test methods have been applied in order to prove

presumption of compliance with the R&TTE Directive 1999/5/EC:

• EN 300 328-2 V1.3.1 (2001-12)- Technical requirements for spread-

spectrum radio equipment

• EN 301 489-17 V1.2.1 (2002-08)- EMC requirements for spread-spectrum

radio equipment

In France there are restrictions in the use of this device.  A restricted

0336

Important Notice:

This device is a portable RF printer intended for com-

mercial and industrial use

in all EU and EFTA mem-

ber states except in France where restrictive use ap-

plies.

continued