Zebra QL Series User Manual - Module Using Pcmcia Radio

37

QL Series User Guide

Frequency Hopping Wireless Local Area Network (WLAN)

Module Using PCMCIA Radio

(QL 320 and QL 420 only)

The following section only applies when the PCMCIA FH WLAN module (FCC ID: I28MD-

QL3201) is installed in a QL 320 or QL 420 printer (note that only one of the radio op-

tions can be installed in a printer at one time). The FCC ID number label is on the front

of the module and can be read with the module installed.

 WARNING: Use of the QL 320 or QL 420 with the radio module

marked with FCC ID: I28MD-QL3201 meets the FCC requirements

for radio frequency (RF) radiation exposure in the standard body

worn configuration with no minimum separation. In this

configuration, which applies whether the belt clip or shoulder

strap is used, the face of the printer from which paper is

transported is facing away from the user’s body. The standard

configuration must always be used when the printer is body worn.

This configuration maintains the required 1 cm separation

distance.

The QL 320 and QL 420 with this radio option have been SAR

tested. The maximum SAR value measured for the QL 320 was .604

W/kg averaged over 1 gram.

The maximum SAR value measured for the QL 420 was .899 W/kg

averaged over 1 gram.

European Regulatory Information for this Radio

AUS

B

DK

FIN

F

D

GR

IRE

I

LUX

NL

P

E

S

UK

Note: -Member states in the EU with restrictive use for this device are

crossed out!  This device can only be used indoors in France.

This device is also authorized for use in all EFTA member states (

CH,

ICE, LI, NOR

)

0336

Important Notice:

This device is a portable RF printer intended for com-

mercial and industrial use

in all EU and EFTA mem-

ber states except in France where restrictive use ap-

plies.

continued