Zektop SoloCAT Z57-1.3 User Manual - Panel Description
Panel Description
Front Panel — Transmitting Unit Z57 [TX]
HDMI IN: Connects to a HDMI™ source with a HDMI male-male cable here
MODE: 0 = [Video] – supports up to HDMI™ 1.3 output. [Audio] – supports up to 7.1ch output
1 = [Video] – supports up to HDMI™ 1.3 output. [Audio] – locks to stereo audio output
2 = [Video] – locks to HDMI™ 1.2 output. [Audio] – supports up to 7.1ch output
3 = [Video] – locks to HDMI™ 1.2 output. [Audio] – locks to stereo audio output
4 = [Video] – DVI display mode. [Audio] – no audio output
5 = [Safe Mode] – uses default EDID
1
with video supported up to 1080p and stereo audio
6 = [Default Mode] – uses default EDID
2
with video supported up to 1080p and 7.1ch audio
7 = [EDID Learning Mode] – learns EDID
3
from the display
Note for EDID (Extended Display Identification Data) learning
1. If you cannot get the audio/video output from the connected display from the first time setup.
Please follow the instructions below to check if the extender is OK:
Step 1 – Please set the rotary arrow on TX at “
Mode 5
” for Safe Mode, and wait for the LED of
the RJ-45 connector blinks for a couple seconds.
Step 2 – Please turn the rotary arrow counterclockwise [
4] from
Mode 5
to
Mode 3
. If you can
get audio/video from the display, you can stay tune at this setting for 720p or 1080i and
stereo audio. If you need to get 720p/1080i with 7.1ch audio output, please turn the
rotary arrow counterclockwise [
4] from
Mode 3
to
Mode 2
. For better audio/video
output, please check Note#2. If you still cannot get the audio/video out normally, please
go on the next step.
Step 3 – Please turn the rotary arrow counterclockwise [
4] from
Mode 3
to
Mode 7
. Wait a few
seconds until the LED of the RJ-45 connector dims and then lights again.
Step 4 – Please turn the rotary arrow clockwise [
3] from
Mode 7
to
Mode 1
. You should have
normal audio/video output. If not, please contact technical support.
2. For desirable 1080p video output, please follow the instructions below:
Step 1 – Please set the rotary arrow on TX at “
Mode 6
” for Default Mode, and wait for the LED
of the RJ-45 connector blinks for a couple seconds.
~ 4 ~