Zektop SoloCAT Z57-1.3 User Manual - page 6
Step 2 – Please turn the rotary arrow clockwise [
3] from
Mode 6
to
Mode 1
. If you can get
audio/video from the display, you can stay tune at this setting for 1080p and stereo
audio. If you need to get 1080p with 7.1ch audio output, please turn the rotary arrow
counterclockwise [
4] from
Mode 1
to
Mode 0
. If you cannot get the audio/video out
normally, please go on the next step.
Step 3 – Please turn the rotary arrow counterclockwise [
4] from
Mode 0/1
to
Mode 7
. Wait a
few seconds until the LED of the RJ-45 connector dims and then lights again.
Step 4 – Please turn the rotary arrow clockwise [
3] from
Mode 7
to
Mode 0/1
. You should
have your desirable audio/video output. If not, please follow the instruction in Note#1.
3. To learn EDID from the HDMI™ display, please follow the instruction below:
Step 1 – Please connect the display which you want to read EDID with a HDMI™ cable to the
transmitter’s HDM™I IN and set the rotary arrow at
Mode 7
so the TX can learn the EDID
information from the connected display. The LED on the RJ45 connector of TX will dim
and light again in a few seconds, which indicates the EDID learning procedure is
complete.
Step 2 – Please turn the rotary arrow clockwise [
3] from
Mode 7
to
Mode 0
or
Mode 1
for
desirable audio setting and enjoy the experience. DO NOT let the rotary arrow pass by
Mode 5
and
Mode 6
which will erase the EDID just learned and restore the default EDID
.
Rear Panel — Transmitting Unit Z57 [TX]
+5V DC: Connect to 5V DC power supply.
HDMI™ Signal OUT: Plug in a Cat-5/5e/6 cable that needs to be linked to the RJ-45 connector of the receiving unit
CV-57G[RX].
~ 5 ~