Zektor MAS7.1 User Manual - Using A Different Remote
10
MAS7.1 Component Video Switch
11
MAS7.1 Component Video Switch
Using a Different Remote
The MAS7.1 features Zektor ’s Exclusive Intelligent-IR™, and with ver y
few exceptions can be set up to use any remote you can point at it!
This is useful if you have more than one MAS7.1 in the same room.
Pick a new remote
Star t by pick ing a new remote you’d like to use with the
MAS7.1.
If you plan on using a universal remote, star t by setting
it up as a remote for a T V or VCR that you don' t own. (For
instance if you don’t own a Sony T V, setup your universal
remote to control a Sony T V.)
Step 1: Put the MAS7.1 into the Setup Mode
The MAS7.1 is placed into the setup mode by pressing and
holding the Power button for about seconds.
Step 2: Select the Intelligent-IR™ Learn Mode
Select the Intelligent-IR™ Learn Mode by pressing ‘1’.
Once the ‘1’ button is pressed, the standby LED will flash
slower and all the other LEDs will turn off. The MAS7.1 is
now waiting for new IR codes to be sent from your remote
control.
Step 3: Teach the MAS7.1 your new remote control codes
On your remote control, press the following buttons, in the
following order:
Power 1 2 3 4 5 6 0
The front panel LED's will sequence as each button is
pressed, and the IR LED will flash for each button -- if not,
see the following section on "More Remote Options".
That ’s it! The MAS7.1 will return to the state it was in before
setup, and will now work with your new remote!
The new control buttons on your remote are...
Power
Toggles the MAS7.1’s power.
1 - 3
Selects inputs 1 through .
4 - 6
Selects inputs S1 through S.
0
Toggles the SYNC LED.
Note:
All remote control codes are saved in non-volatile
memor y and will not be lost during a power failure.
•
•
•
•
•
•
•
•
1 2 3 S1 S2 S3 SYNC
Step 1: Put the MAS7.1 into the Setup Mode
Press and hold the Power Button for secs.
The front panel LEDs will start to blink
wildly... (You’ll know it when it happens!)
Step 2: Press the ‘1’ button for Intelligent-IR™ learning
1 2 3 S1 S2 S3 SYNC
Step 3: Teach the MAS7.1 its new IR codes
1 2 3 S1 S2 S3 SYNC
1 2 3
4 5 6
7 8 9
0
+ +
_ _
POWER
VOL
CH
Press the following sequence of buttons on
your remote control:
Power 1 2 3 4 5 6 0
That’s it! The MAS7.1 now operates with
your new remote control!
Once the 1 button is pressed, the
standby LED will flash slower, and
all the other LEDs will turn off.