Zelmer 1600.0 Service Manual - page 16
Strona 16 z 21
VACUUM CLEANER DISASSEMBLY
Before attempting disassembly, carefully read this service manual and the
product's operation manual.
Disassembly of 1600 vacuums
Fig. 1 Position of catches fixing
the container catch
Fig.2 Position of catches fixing
the rewinder insert
Disassembly should be performed on a table covered with clean felt or other soft
material, taking care not to scratch the plastic parts. Set the vacuum cleaner on the table:
Release the container catch 9 and open the container 1, remove the bag from the
container.
Use a thin rod to knock the two container axles 24 out of the container and remove the
container 1 from the body 2.
Remove screws 102 and 103 and remove the gasket frame 10 from the container, along
with the container gasket 20. Remove the container gasket 20 from the gasket frame 10.
Insert a thin screwdriver into the gap between the container 1 and the interlock 11 (fig. 1)
and bend out two visible catches z1, simultaneously pulling the container catch 9 towards
you.
Remove the container catch 9 with interlock 11 and spring 23 from the container.
Remove the interlock and the spring from the catch.
Remove screw 105,then release the two spring catches and slide the container casket
out 15.
Remove the cover 16 from the container casket by releasing the two spring catches.
After removing the cover, slide two springs 40 out of their sockets.Unscrew two screws
106 from the container and pull out the front strip 14.
Remove screw 104, remove the washer 101 and the front wheel support 29 from the
container's 1 sleeve.
Bend out the support's catches 29 to remove the front wheel 30. Proceed similarly with
the second wheel.
Open the accessories cover 8 and pull it back while lifting its axle over the ribs of the
body and releasing its catches. Remove the accessories.
Simultaneously push both catches on the filter cover 7 to open it and remove it from the
body 2. Remove the outlet filter 37 from the outlet.
Remove four screws 102 mounting the plate 3 by pulling it away from the body until it
automatically releases from the catches. Before setting the plate aside remember to